Function : Decorative,Explosion-Proof,Heat Insulation,UV Protection,DIY,Heat Control,privacy protection,security theft,furniture protection
Surface Treatment : Embossed,Frosted / Etched,Opaque,Stained,Electroplated,MIRROR,electrostatic adsorption,3D
Type : Glass Films
Feature : Self-Adhesive,Static Cling
Material : PET
Origin : China
size : wide 30cm 45cm 60cm 75cm 90cm by long 100cm or 200cm
name : window privacy film vinyl for glass windows
window film : window sticker window film anti look
stained glass : privacy film window sticker for glass window
window tint : adhesive for glass windows adhesive window film
window vinyl : stained glass window film
term of use : Five to eight years.
AFDB window film use glue-free materials, easy to install, gives privacy and decorate while allowing plenty of light in. Meanwhile, AFDB window film will block 96% of UV-Rays,protect your skin and furniture.
Privacy Effect for Different Distance This pattern of window film will provide you a good privacy. It is highly recommended for the privacy needed place, such as a washroom ,bedroom or basement window. You will love to have a DIY with it to decorate your kitchen, living room and front doors etc. Let's go to dress up you windows!
Tips for Installation:
A clean and smooth glass surface without any dust, fiber or any kind of texture is needed.
The transparent back cover must be peeled off; otherwise, the film will fall off when the water is dry.
Do not apply to the window frame. Cut off excessive edges after application if needed.
The film may be a little tough and its adhesive effect will be impacted in winter. Solution: use hair dryer or warm water to soft it. ( Heat resistance is under 176℉).
EnviromentalAll materials of Cottoncolors Window films are NON-TOXIC and pollution-free.
RecyclabilitySelf-sticker (No-glue) design makes the window film reusable.Keep the glass clean.
ReputablyExcellent texture provides you with privacy and beauty at the same time.
1.Clean the window glass.
2.Wet the window glass with soapy water.( PS: Mix a little soap or detergent with a lot of water)
3.Measure windows and trim film.
4.Affix tapes on both sides to remove the transparent backing film. (PS: It is a very important step that the window film cannot be stuck if it is ignored)
5.Install the film to the glass.
6.Squeeze out water and air bubbles with a smooth tool, such as a credit card or a spatula. (No spatula or squeegee is included in this item).
Q & A
Q1:Why the window film can't stick to the window(falling down)?
A1: There are so many reason which will be caused window film falling.
1.The transparent backing film didn't peel off; 2.The window glass is not smooth; 3.Too less water when install the film;4.Applied the wrong side.Please apply the smooth side to the window.
Q2: Why there are so many bubbles in the window film?
A2:Please spray more soapy water on window,and repaste it again.
Q3: Why the edge of window film curling up?
A3: The edge of film is paste to the window frame. Please leave a small gap(2-3mm) between the film and frame.
The cold weather also may affect the application. Please try to blow the films with a hair dryer or soften it by soaking in warm water. Set a hairdryer to high heat with low speed and run it over the film, holding 1"-2" (2.5-5cm) away from the film surface.
