introduction TAGATORON carbon rear anchor set rear anchor assembly set [Gimmick series] 1-axis (1-axis [for MS])

✅The recovery rate is greatly improved due to the "inertia effect" when landing due to vertical movement. ✅ Less lateral play reduces deceleration in corners. ✅For MS chassis only. Bumper cutting of the chassis is required for installation. You will also need to prepare a hammer, screwdriver, and wrench separately for assembly. ✅Uses "skin punch type shaft hole machining" which is a hot topic on YouTube (official license has been obtained from the developer) ✅This product is not manufactured by Tamiya Co., Ltd. It was created to be used as an introduction to parts processing, and to allow you to easily enjoy the gimmick in personal races. It cannot be used in official Mini 4WD competitions or races based on official competition rules. Product introduction ●Recovery rate is significantly increased due to the “no effect” when landing due to vertical movement ●Since there is little lateral play, deceleration at corners is suppressed. ●For MS chassis only. Bumper cutting of the chassis is required for installation. You will also need to prepare a hammer, screwdriver, and wrench separately for assembly. ●Uses "skin punch type shaft hole machining" which is a hot topic on YouTube (official license has been obtained from the developer) -This product is not manufactured by Tamiya Co., Ltd. It was created to be used as an introduction to parts processing, and to allow you to easily enjoy the gimmick in personal races. It cannot be used in official Mini 4WD competitions or races based on official competition rules.